JA
  • English
Login

TMC Undervoltage error #04313 (MMU)

Menu
Relevant for:
Last updated a year ago
This article is also available in following languages: 
EN

What happened?

Each of the three stepper motors on the MMU unit is controlled by a TMC driver on the control board. This message is shown in case the TMC driver for the Selector does not have enough current.

How to fix it?

Check the wiring and connectors on the MMU board.

Make sure your MMU3 unit is correctly assembled with the PD-board addon attached.

In case the issue persists, contact our カスタマーサポート.

Was this article helpful?

Comments

Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us