JA
  • English
  • Čeština
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français
Login

Loadcell not calibrated #17523 (XL)

Menu
Relevant for:
Last updated 2 months ago
This article is also available in following languages: 
ENCSPLDEESITFR

What happened?

The Original Prusa XL is equipped with a loadcell, to detect that the nozzle is close enough to the steel sheet for printing, and to avoid damage that would be caused by the nozzle digging into the steel sheet. 

During a selftest the loadcell is calibrated. The loadcell can also be calibrated at any time through the printer menu. If the loadcell calibration is not done, or the printer does not recognize that it has been done, it will show the message "Loadcell calibration is incomplete. Restart the printer and calibrate loadcell."

Error name: Loadcell not calibrated 

Error code: #17523

How to fix it? 

A visual inspection

Before you start, make sure:

  • the filament is unloaded from the extruder
  • the printer is turned OFF and unplugged from electricity
  • the hotend and the heatbed are cooled down to ambient temperature
Since we will handle tools and work with the extruder high above the heatbed, it is necessary to protect it.
Place an empty Prusament cardboard box approximately to the front center part of the heated. Move the X-axis all the way to the front side of the printer, and move the extruder approximately to the center of the X-axis.
 

Open the dwarf-cover-door to access the Dwarf board. The loadcell connector is on the bottom left, check it for any loose cable, disconnected cable, or visible damage. 

Re-calibrate the loadcell

Do not manipulate or touch the printer unless the instructions on the printer screen prompt you to do so.

Navigate to LCD Menu - Control - Calibration and test - Loadcell test to restart the loadcell calibration.

During the test, you will be asked to tap the nozzle at a specific time, and a progress bar on top of the screen will be filled. If the progress bar is not filled or the printer shows any errors, please contact our customer support.

Was this article helpful?

Comments

Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us