JA
  • English
  • Čeština
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français
Login

BBF Initialization failed #17532 (XL)

Menu
Relevant for:
Last updated a year ago
This article is also available in following languages: 
ENCSPLDEESITFR

What happened?

The Original Prusa XL firmware is in BBF format. When flashing firmware, this is copied from the USB drive to the XL internal memory. In case of an issue at the start of this procedure, the printer will show the message "BBF initialization failed, repeat the action or try another USB drive."

Error name: BBF Initialization failed

Error code: #17532 

How to fix it?

Re-flash firmware

Download the firmware and if necessary the bootloader, and transfer it to your USB drive. Make sure to unmount the drive from your operating system before physically removing it.

Insert the USB drive back into the printer and reboot the printer using the reset button directly next to the knob to initiate the flashing procedure. In case the procedure does not start, reboot the printer again by pressing the same reset button, and while the printer is booting up, press once the rotating knob.

The printer will let you know when the flashing is done. When installing the bootloader along with the firmware, it may take several minutes.

Use another USB drive

If the issue persists, attempt flashing firmware using any other USB drive in your household. Make sure this is formatted to FAT32, copy both firmware files, and repeat the previously described procedure.

Are you still having issues? Contact our support team and let them know that you tried to fix the issue with these instructions. We will take it from there.

Was this article helpful?

Comments

Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us