JA
  • English
Login

Filament already loaded #04501 (MMU)

Menu
Relevant for:
Last updated a year ago
This article is also available in following languages: 
EN

What happened?

Other than the sensors (SuperFINDA and Extruder filament sensor), the MMU also has a record of filament being loaded or unloaded. This way, the unit can stay reliable even in case the sensors are not properly calibrated or are damaged.

If there is a record of filament being loaded into the extruder, there is a green light for the corresponding filament position on the MMU unit. If you attempt to load another filament while there is a record that the filament is already loaded, this error will be shown.

How to fix it?

First, hit Unload filament in the LCD menu, the filament will unload and the Filament Loaded record will be cleared.

In case you have unloaded the filament by hand, the printer might not know about it. Next time, use the Unload Filament function from the menu.

If the printer just started up or was restarted, the “FilamentLoaded” record is cleared automatically if both SuperFINDA and the filament sensor in the extruder do not detect a filament.

Was this article helpful?

Comments

Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us