日本語
Login

Factory Reset (MMU)

関連するもの

MMU2S
MMU3
記事 他の言語でもご覧になれます。
English
Čeština
Polski
Deutsch
Français
Español
Italiano
日本語
This procedure is the same for the MMU3 and MMU2S units running firmware 3.0.0 or newer. In case you are running MMU2S with older FW, please go to Factory reset (MMU2S pre firmware 1.0.6) [進行中の翻訳].

When upgrading the MMU2S firmware from firmware 1.0.6 (or lower) to 3.0.0 (or higher), or when you find a severe issue with the MMU, you might need to perform a factory reset.

  1. On the MMU unit, hold the left side button and reset the unit by pushing the button on the right side of the MMU with an Allen key.
  1. Keep the left side button pressed for a few seconds. You will see the LEDs on the MMU flashing quickly in a "snake" motion.
  2. Release the MMU left-side button. As soon as you release it, the MMU EEPROM will be cleared and overwritten with factory default values and will do the selftest.

You have successfully reset the MMU. No indication will be shown on the MMU or on the printer.

 
ログイン してコメントを投稿する
コメントなし