Warning: TMC too hot #04221 (MMU)

Relevant for:

Last updated a year ago

This article is also available in following languages:

What happened?

Each of the three stepper motors on the MMU unit is controlled by a TMC driver on the control board. This message is shown in case the TMC driver for the Idler motor is almost overheated.

How to fix it?

Make sure that there is sufficient airflow near the MMU board.

If you are using the printer in an enclosure with elevated temperatures, use ventilation to cool down the printer’s environment.

This is a warning and the print will be able to continue, but make sure to correct it or you might damage the hardware.

Was this article helpful?

Easy to understand

Solved my problem

Other reason

Comments

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.