ESP Error #26505 (MK4S) #13505 (MK4) #21505 (MK3.9) #23505 (MK3.5)

Relevant for:

MK4 MK3.9 MK3.5 MK4S

Last updated 4 months ago

This article is also available in following languages:

What happened?

The printer is showing the message "Command error"

Error name: ESP Error

Error code: #26505 (MK4S) #13505 (MK4) #21505 (MK3.9) #23505 (MK3.5)

On the Original Prusa MK4/MK3.9/MK3.5, the xBuddy board can be extended with a Wi-Fi module. The error is triggered when the xBuddy is not able to correctly control the Wi-Fi module, needed to achieve Wi-Fi connectivity.

How to fix it?

Re-flash firmware

The firmware needed for the Wi-Fi module is included in the MK4S/MK4/MK3.9/MK3.5 firmware file. Download the firmware and if necessary the bootloader, and transfer it to your USB drive. Make sure to unmount the drive from your operating system before physically removing it.

Insert the USB drive back into the printer and reboot the printer using the reset button directly next to the knob to initiate the flashing procedure. In case the procedure does not start, reboot the printer again by pressing the same reset button, and while the printer is booting up, press once the rotating knob.

The printer will let you know when the flashing is done. When installing the bootloader along with the firmware, it may take several minutes.

A visual inspection

Before accessing any of the electronic boards, ensure that the printer is fully cooled down, and switched off for at least 10 minutes.

Access the xBuddy board by loosening the four screws in the below picture, and inspect it for any visible damage.

Are you still having issues? Contact our support team and let them know that you tried to fix the issue with these instructions. We will take it from there.

Was this article helpful?

Easy to understand

Solved my problem

Other reason

Comments

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.