EN
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français
Login

Filament sensor too early #04106 (MMU)

Menu
Relevant for:
Last updated a year ago
This article is also available in following languages: 
PLDEESITFR

What happened?

Implausible reading by the Filament sensor inside the extruder, while loading a filament. The filament shouldn't be in the extruder yet but is detected there anyway. 

How to fix it?

Remake the IR filament sensor calibration (MMU3, MMU2S)

Open the extruder idler and make sure that there is no leftover filament in the extruder causing the sensor to trigger too early.

Was this article helpful?

Comments

Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us