The Original Prusa MK4/MK3.9/MK3.5 is showing the message: "Emergency stop invoked by G-code (M112)".
Error name: Emergency stop
Error code: #26510 (MK4S) #13510 (MK4) #21510 (MK3.9) #23510 (MK3.5)
This error message can be triggered during serial printing (e.g. Octoprint) and blocks the printer control.
Temporarily disconnect from your printer any external device, reboot the printer, and try printing using a FAT32 formatted USB drive. See if a different error would occur while printing via USB drive, and check the article relative to the new error.
If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.