Flash erase error #26605 (MK4S) #13605 (MK4) #21605 (MK3.9) #23605 (MK3.5)

Relevant for:

MK4 MK3.9 MK3.5 MK4S

Last updated 3 months ago

This article is also available in following languages:

What happened?

While flashing firmware to your Original Prusa MK4, MK3.9, or MK3.5, an error might occur, and the screen will display the following message: "Error erasing flash! Restart the printer and try again".

Error name: Flash erase error

Error code: #26605 (MK4S) #13605 (MK4) #21605 (MK3.9) #23605 (MK3.5)

This error is shown when the printer has failed to delete the internal flash memory, so the new firmware can't be flashed.

How to fix it?

Re-flash firmware

Download the firmware and if necessary the bootloader, and transfer it to your USB drive. Make sure to unmount the drive from your operating system before physically removing it.

Insert the USB drive back into the printer and reboot the printer using the reset button directly next to the knob to initiate the flashing procedure. In case the procedure does not start, reboot the printer again by pressing the same reset button, and while the printer is booting up, press once the rotating knob.

If the issue persists, the problem might be in the USB flash drive. Find any other USB drive in your household, make sure it is formatted to FAT32, copy both firmware files, and repeat the previously described procedure.

A visual inspection

Access the xBuddy board by loosening the four screws in the below picture, and inspect it for any visible damage.

Are you still having issues? Contact our support team and let them know that you tried to fix the issue with these instructions. We will take it from there.

Was this article helpful?

Easy to understand

Solved my problem

Other reason

Comments

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.