JA
  • English
  • Čeština
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français
Login

LCD brightness adjustment (MK3S)

Menu
Relevant for:
Last updated 3 years ago
This article is also available in following languages: 
ENCSPLDEESITFR

Starting firmware version 3.9.0, for the Original Prusa MK3S manufactured after June 2019, it is possible to adjust the brightness of the screen directly from the LCD menu and also have the option of dynamic lighting, triggered by navigating the LCD menu.

Printers received before June 2019 including the MK3 model may not have the compatible components for this feature. EinsyRambo rev. 1.1a, and an LCD panel supplied after June 2019 is required. These can be purchased in our eshop (note that you have to be logged in).

If your mainboard or LCD module does not support this feature you will not appear in the menu as an option.

Modes

Auto - LCD display goes from 'Level Dimmed' value to the 'Level Bright' value when interacted with.

Bright - LCD brightness level always on the Level Bright Value

Dim - LCD brightness level always on the Level Dimmed Value

How to adjust

All parameters can be found under Settings -> Brightness, on the LCD-menu.

  • Level Bright: 10-255 - Light level of LCD display when active/Bright.
  • Level Dimmed: 0-255 - Light level of LCD display when inactive/Dimmed. The 'Level Dimmed' value cannot be higher than the 'Level Bright' value.
  • Mode: [Auto/Bright/Dim] - Dynamic light (Auto), constant Bright or constant Dim light level.
  • Timeout: 0-999: Duration in seconds it takes to go from Bright to Dim when in Auto mode. 
For contrast adjustment of the display, please see LCD screen contrast adjustment (i3) [進行中の翻訳].

Was this article helpful?

Comments

Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us