Each of the three stepper motors on the MMU unit is controlled by a TMC driver on the control board. This message is shown in case the TMC driver for the Selector does not have enough current.
Check the wiring and connectors on the MMU board.
Make sure your MMU3 unit is correctly assembled with the PD-board addon attached.
In case the issue persists, contact our Support client.
Si vous avez une question sur un sujet qui n'est pas traité ici, consultez nos ressources supplémentaires.
Et si cela ne suffit pas, vous pouvez envoyer une demande à [email protected] ou via le bouton ci-dessous.