Each of the three stepper motors on the MMU unit is controlled by a TMC driver on the control board. In case there is an unexpected communication issue between the main microcontroller and the Selector motor TMC driver on the board, the error is shown.
Make sure you are using the MMU3 with the PD-board addon attached.
Verify all the cables are in good condition and the connections are stable.
Si tienes alguna pregunta sobre algo que no se ha tratado aquí, comprueba nuestros recursos adicionales.
Y si eso no lo soluciona, puedes enviar una petición a [email protected] o mediante el botón que hay más abajo.