English
Čeština
Español
Italiano
Deutsch
Polski
Français

PrusA64 mainboard electronics wiring (SL1)

Relevant for:

SL1

Last updated 4 years ago

This article is also available in following languages:

With the technology used in MSLA 3D printing, the Original Prusa SL1 has a different mainboard arrangement compared to our FFF printers. It uses two boards instead of one:

PrusA64 mainboard with A64 ARM CPU and graphics driver for both screens
Motion controller board (MC) with drivers controlling all movements (tilt and tower)

Electronics wiring

For the exact order of the wiring and cable management, we recommend seeing the electronics section of the assembly manual.

If you are replacing the PrusA64 board, please see our guide How to replace the A64 board (SL1) [進行中の翻訳].

Was this article helpful?

Easy to understand

Solved my problem

Other reason

Comments

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.