I agree with others that a set of hex drivers , along with a couple of ball ends for quick light angular tightening, will speed things up. And, a good curved end hemostat for placing small nuts into tight captured impressions; then open them slightly, placing each jaw on the edge of the nuts and, using your other hand press down on the jaws to fully seat the nut.. Also, the nylok nuts seem to take a 5.5mm socket driver. Luckily, I found an old 7/32” laying around that worked fine.
Diagonal cutters for trimming cable ties. It would be nice if the kit included either 3D printed or metal stamped open end wrenches of the sizes mentioned in the comment above. Getting precise tightening of the small nuts is difficult with the supplied needlenose pliers and is prone to damaging the nut.
