⬢Versions of the MINI+ kit assembly manual:
⬢01/2021 - Initial version 1.05
⬢02/2021 - Updated to version 1.06
⬢03/2021 - Updated to version 1.07
⬢11/2021 - Updated to version 1.08
⬢05/2023 - Updated to version 1.09
JA
Login- English
- Čeština
- Español
- Italiano
- Deutsch
- Polski
- Français
- Home
- MINI+
- 組立てガイド
- MINI+ kit assembly (draft) [進行中の翻訳]
- Manual changelog MINI+ kit
Manual changelog MINI+ kit
Menu
- MINI+ kit assembly (draft) [進行中の翻訳]
- 1. Introduction
- 2. YZ - axis assembly
- 3. X-axis & Extruder assembly
- 4. Print head & Heatbed assembly
- 5. LCD assembly & Electronics
- 6A. Spool holder assembly
- 6B. Spool holder assembly
- 7. Preflight check
- Manual changelog MINI+ kit
- 1. Version history
- 2. マニュアルの変更点 (1)
- 3. マニュアルの変更点 (2)
- 4. マニュアルの変更点 (3)
- 5. マニュアルの変更点 (4)
Manual changelog MINI+ kit
Relevant for:
Last updated 6 months ago Difficulty
Very easy Steps
5 Available languages
⬢02/2021 - YZ-axis assembly
⬢Improved inspection holes to check the insertion of the smooth rods in the MINI-Z-bottom.
⬢02/2021 - X-axis & Extruder assembly
⬢Added inspection holes to check the insertion of the smooth rods in the MINI-X-end.
⬢02/2021 - X-axis & Extruder assembly
⬢The dimension of the gap between the motor and the X-axis pulley has been changed from 2 mm to 0.7 - 1 mm.
Manual version 1.06
⬢03/2021 - Print head & Heatbed assembly
⬢Added instruction for firmly tightening screws on heatbed cables.
Manual version 1.07
⬢11/2021 - LCD assembly & Electronics
⬢New kit units are shipped with a silver label already affixed to the Z-axis extrusion.
Manual version 1.08
⬢05/2023 - Spool holder assembly
⬢Added instructions for assembling the new version of the Spool holder (injection molded).
Manual version 1.09
Was this guide helpful?
Comments
Still have questions?
If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.