1. Tools necessary for this chapter

Original Prusa i3 MK3 to MK3S+ upgrade [進行中の翻訳]

• 1. Introduction
• 2A. MK3 Extruder disassembly
• 2B. MK3S Extruder disassembly
• 3A. MK3 Extruder upgrade
• 3B. MK3S Extruder upgrade
• 4. Electronics assembly
• 5. Y-axis upgrade [進行中の翻訳]
  1. Tools necessary for this chapter
  2. New LCD-knob installation (optional)
  3. Removing the heatbed
  4. Bearing clips assembly - parts preparation
  5. Bearing clips assembly
  6. Bearing clips assembly
  7. Bearing clips assembly
  8. ヒートベッドを取り付ける (パート 1)
  9. ヒートベッドを取り付ける (パート 2)
  10. ヒートベッドを取り付ける (パート 3)
  11. ヒートベッドを取り付ける (パート 4)
  12. New Y-rod holders installation - parts preparation
  13. Preparing Y-rod-holder
  14. Removing the Y-rod-holders (rear side)
  15. New Y-rod holders installation (rear side)
  16. Removing the Y-rod-holders (front side)
  17. New Y-rod holders installation (front side)
  18. スムーズロッド の調整
  19. Y-axis is finished!
• 6. Preflight check