EN
  • Čeština
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français
Login

IPA pigment filter

IPA pigment filter

IPA pigment filter
Relevant for:
Last updated a year ago
IPA pigment filter
 Difficulty
Very easy
 Steps
8
 Available languages
CSPLDEESITFR
Introduction
Introduction
The filter can be used in CW1 /CW1S.
The filter can be purchased on https://www.prusa3d.com.
Print models can be downloaded here. Models are for both SLA and FDM.
New CW1 / CW1S 3.3.0 firmware includes IPA filtering mode.
Be gentle, more pressure can damage or tear the filter.
Assembling the filter holder
Assembling the filter holder
Assembling the filter holder
Assembling the filter holder
Assemble the filter before mounting to the CW, otherwise you can damage the filter if you going to complete the top and bottom printed parts after the filter is installed.
Parts have printed locking elements.
Insert the filter holder top part into the filter holder bottom printed part as described in the picture. Locking parts has to be inserted correctly.
Turn the filter holder top part to the left to secure both parts together.
Preparing the filter
Preparing the filter
Preparing the filter
Preparing the filter
Be gentle, more pressure can damage or tear the filter.
Gently take the last folded sheet and insert it into the left glued sheet.
Gently push the folded sheet to secure it inside the glued sheet.
The filter is ready.
Completing
Completing
Completing
Completing
Be gentle, more pressure can damage or tear the filter.
Insert 3-4 fingers into the prepared filter.
Use your fingers to gently open the filter as described in the picture.
Every blade of the printed part has one own filter sheet.
Use your fingers to open each filter sheet and insert the printed part into the filter clockwise.
Filter securing
Filter securing
Filter securing
Filter securing
The printed part has 3 locks around the perimeter.
Be gentle, more pressure can damage or tear the filter.
Gently push the filter towards the printed part and secure the position in 3 locks around the perimeter.
The filter is prepared and secured.
Inserting into CW
Inserting into CW
Inserting into CW
Inserting into CW
Use gloves. The CW1 / CW1S parts may be wet from the IPA.
For this step, please prepare these things:
CW1 / CW1S Stainless steel tank lid
Assembled IPA pigment filter
On the tank lid, press the plastic button to push out the knob from the opposite side.
When the knob is pushed out, slide the IPA filter assembly onto the holder from the bottom side.
Was this guide helpful?

Comments

Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us