⬢In case you have the old version of the buffer in the assembled state, it is necessary to disassemble it first.
We will re-use only the six large plastic plates from it.
⬢If you have the plastic sheets alone, please skip to the next chapter.
JA
Login- English
- Čeština
- Español
- Italiano
- Deutsch
- Polski
- Français
- Home
- MMU3
- 組立てガイド
- Original Prusa MMU3 キット組立て
- 3. MMU2S Buffer Disassembly (UPG)
3. MMU2S Buffer Disassembly (UPG)
Menu
- Original Prusa MMU3 キット組立て
- 1. はじめに
- 2. MMU2Sの分解 (アップグレードキット)
- 3. MMU2S Buffer Disassembly (UPG)
- 1. 準備
- 2. PTFEチューブの取り外し
- 3. Buffer disassembly
- 4. Summary
- 4.アイドラーボディの組み立て
- 5.セレクターの組み立て
- 6. Pulley Body Assembly
- 7. Cassette Buffer Assembly
- 8. Spool holder Assembly
- 9A. MK4/S, MK3.9/S Nextruder mod
- 9B. MK3S+ / MK3.5 Extruder mod (KIT)
- 9C. MK3S+ Extruder (UPG)
- 10A. MK4/S, MK3.9/S Setup and Calibration
- 10B. MK3S+ Setup and Calibration
- 10C. MK3.5 Setup and Calibration
- 11. ファーストフライト
3. MMU2S Buffer Disassembly (UPG)
Relevant for:
Last updated 4 months ago Difficulty
Easy Steps
4 Available languages
⬢Remove the five M3x10 screws holding the PTFE tubes in the buffer.
⬢Pull all the PTFE tubes out.
Dispose of the tubes to prevent them from getting mixed up with the new ones in the future. These tubes will not be used again.
⬢Remove the ten M3x40 screws.
⬢Remove all the printed parts.
Set the printed parts aside so that they don't mix up with the new parts. These parts won’t be re-used.
That was simple, wasn't it?
⬢From the disassembled buffer, please save the buffer plates for later use.
Was this guide helpful?
Comments
Still have questions?
If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.