⬢両方のアイドラーネジを取り外します。
⬢Ensure that idler can move freely on screw, if not the case slightly loose screw holding idler in place.
Be aware of M3nS nuts for idler screws as they can fall from slots.
JA
Login- English
- Čeština
- Español
- Italiano
- Deutsch
- Polski
- Français
- Home
- MMU1
- Troubleshooting [進行中の翻訳]
- プリンタートラブルシューティング
- MMU1のフィラメントプーリー
MMU1のフィラメントプーリー
Menu
MMU1のフィラメントプーリー
Relevant for:
Last updated a year ago Difficulty
Moderate Steps
4 Available languages
⬢Clean milled slot on both pulleys from filament residue.
⬢Make sure milled slot on motor mounted pulley is perfectly in center with filament.
⬢Make sure grub screw is tight and pulley is secured in place.
⬢After you're done, assemble the idler back together.
⬢Tighten the screws, the gap between washer and idler (printed part) should be 4-5 mm.
This photo is just for illustration, you don't have to remove the extruder from the printer.
Was this guide helpful?
Comments
Still have questions?
If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.