⬢SuperLube (1x)

⬢Pair of gloves (1x)

Tools that are not supplied but can make maintenance easier.

⬢Paper towels to wipe off grease.

⬢Piece of cloth to heatbed protection during assembly. 

⬢Flat screwdriver

⬢Cool down the printer. Go to More > Temperature > Cooldown. Wait till the printer is cooled down!

⬢Turn the power switch OFF (symbol "O").

From now on we will demonstrate the lubrication of the Magballs on the printer with the lights on for better visibility inside the printer. Please note, do not switch ON the printer. The printer in the pictures is shown with the lights on for better visualisation for customers.

⬢Open the lid.

⬢Using a flat screwdriver, loosen the Door-opening-stopper by turning it 120° counter-clockwise.

⬢Remove the Door-opening-stopper by pushing from the inside of the printer.

⬢Repeat the process on the second Door-opening-stopper on the other side of the lid.

⬢Before you proceed, it is recommended to protect the heatbed.

⬢Place the dust cloth approximately to the front center part of the heatbed.

⬢Put the gloves on both your hands.

⬢Carefully remove the first carbon rod from the print head magball by pulling it away.

⬢Remove all remaining carbon rods from the print head magballs.

⬢Leave the print head on the cloth.

Note that all carbon rods are numbered.

The rods are attached to magnetic balls.

⬢Carefully remove the carbon rods 1 and 2 from the left carriage by pulling them away.

⬢Carefully remove the carbon rods 3 and 4 from the rear carriage by pulling them away.

⬢Carefully remove the carbon rods 5 and 6 from the right carriage by pulling them away.

⬢Use a paper towel to clean the magballs on the print head.

⬢Use a paper towel to clean the magballs on the carriages.

⬢Check the carbon rods one by one. If it's dirty, clean it.

⬢Use a paper towel to remove any old lubricant from the top and the bottom of the rod.

⬢The top and bottom of the carbon rod must be clean. Look at the picture.

⬢Open the SuperLube.

⬢Gently squeeze the lubricant and apply a small amount to the carbon rod:

⬢Repeat this process for the remaining carbon rods.

⬢Carefully attach the first carbon rod to the magball head and rotate the carbon rod a few times to spread the SuperLube.

⬢Wipe off excess lubricant from surrounding parts to avoid greasing the printing plate.

Note that all carbon rods are numbered.

⬢Carefully attach the second carbon rod to the rear magball on the left carriage.

⬢Carefully attach the third carbon rod to the left magball and the fourth carbon rod to the right magball on the rear carriage.

⬢Carefully attach the fifth carbon rod to the rear magball and the sixth carbon rod to the front magball on the right carriage.

⬢Wipe off excess lubricant from surrounding parts to avoid greasing the printing plate.

⬢Attach the carbon rods one by one to the print head magballs.

⬢Attach remaining carbon rods (2-6).

⬢Now slowly pull the lid downwards until the plastic cut-outs for the Door-opening-stopper are under the top panel. See the picture.

⬢Using a flat screwdriver, secure the Door-opening-stopper by turning it clockwise.

⬢Repeat this process on the left side of the lid.

⬢Close the lid

⬢Remove the dust cloth from the bottom.

⬢Enciende el interruptor (símbolo "I").