⬢Click the button to go to menu.
⬢Go to Prepare
⬢Go to Preheat ABS
⬢Click Preheat ABS 1
JA
Login- English
- Home
- Plus 1.75 mm
- 組立てガイド
- Original Prusa i3 Plus 1.75 mm kit assembly [進行中の翻訳]
- Calibrate i3 Plus LCD/SD
Calibrate i3 Plus LCD/SD
Menu
- Original Prusa i3 Plus 1.75 mm kit assembly [進行中の翻訳]
- Calibrate i3 Plus LCD/SD
- 1. Preheat the printer
- 2. Wait for the temperature
- 3. Home the axes
- 4. Adjust the corners
- Introduction
- First print i3 Plus LCD/SD
Calibrate i3 Plus LCD/SD
Relevant for:
Last updated 5 years ago Difficulty
Moderate Steps
4 Available languages
⬢It is important to let the printer preheating for at least 10 minutes.
When the temperature reaches 50'C, check if fan on the nozzle is running! If not, disconnect the printer and check the connection of nozzle fan!
⬢Go to Prepare
⬢Click Auto home. Printer will move all its axes to the origin.
⬢Click 'Disable steppers'. That will allow you to move the X carriage and printbed by hand.
⬢Move the head and printbed in a way that printhead is in the corner.
⬢With a regular business card (250g), check the distance between the tip of the nozzle and bed.
⬢Adjust the height of the bed with the adjuster ring. You should be able to easily slide the business card between the nozzle and the bed with a little bite. We call it Al dente ;-)
⬢After adjusting, alway compress the bolt against the blue frame under the printbed. Gravity is not always enough to settle it after adjusting.
⬢Repeat for all 4 corners.
⬢YOU ARE DONE!
Was this guide helpful?
Comments
Still have questions?
If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.