Step 3 Preparing the LCD support for assembly Previous Next⬢Prepare the LCD controller and LCD-support printed parts as shown in the picture.Ensure the correct orientation of parts and the LCD controller.⬢Slide the LCD-support parts on the LCD-controller.The exact position will be adjusted in the next step, no need to worry at this moment.You can now remove the protective foil from the LCD panel.Cables are plugged to the LCD from the factory, but you can disconnect them. Add a comment
Step 4 Adjusting the LCD-support⬢Adjust the LCD-support parts as shown in the picture.⬢LCD-support parts must face directly into the cutouts in the LCD-cover. Add a comment
Step 5 Assembling the LCD-cover Previous Next⬢Press the LCD controller with the LCD-support into the LCD-cover as shown in the picture.⬢Press it as deep as possible.⬢The LCD controller must click under support in the center of the LCD-cover. Add a comment
Step 6 Securing the LCD controller Previous Next⬢M3x10 screws (2 pcs)⬢Using the 2.5mm hex spanner, secure the LCD controller in place. Add a comment
Step 7 Assembling the LCD knob Previous Next⬢Assemble the LCD-knob part as shown in the picture. Add a comment
Step 8 Plug in the cables Previous Next⬢Plug in the cables as shown in the picture.⬢Cable with 1 stripe has to be plugged in the connector labeled with EXP1.⬢Cable with 2 stripes has to be plugged in the connector labeled with EXP2. Add a comment
Step 9 Secure the LCD display onto the printer Previous Next⬢Press the LCD assembly onto the front side of the Y-axis.Best way is to press the LCD assembly on the top threaded rod first and then on the bottom.⬢Guide the LCD cables in between threaded rods as in the picture. Add a comment
Step 10 Secure the LCD assembly Previous Next⬢Use the zipties to anchor the LCD assembly to the threaded rods. Add a comment
Step 11 Guiding the LCD cables Previous Next⬢Guide the LCD cables using LCD-clips as seen in the picture.⬢Reverse direction of each of the clip, to prevent side movement of the cables. Add a comment
Step 12 All done!⬢Congratulations! You've attached the LCD to the Prusa i3 3D printer!⬢You can continue by assembling the PSU and the heatbed in the next chapter - 7. PSU & Heatbed assembly [進行中の翻訳]. Add a comment