![Tools necessary for this chapter](https://cdn.help.prusa3d.com/wp-content/uploads/2022/02/258657b0e2ed2748_painted.jpeg)
⬢この章で準備するもの:
⬢M3 ネジ 用の 2.5mm 六角レンチ
⬢ナットの調整用の 2mm 六角レンチ
⬢Needle-nose pliers for zip tie trimming
⬢Philips screw-driver for power cable assembly
⬢8mm wrench to tighten the QSM fittings
Older units may include a side wrench 8 mm.
If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.