1. Tools necessary for this chapter

Original Prusa XL Double-head to Five-head upgrade [進行中の翻訳] (1.01)

• 1. Introduction
• 2. Printer preparing
• 3. Detaching the Nextruder
• 4. PSU & electronics assembly
• 5. Nextruder & accessories assembly [進行中の翻訳]
  1. Tools necessary for this chapter
  2. Filament sensor: parts preparation
  3. Right filament sensor
  4. Nextruder cable: parts preparation
  5. Nozzle seal versions
  6. Version C: preparing the dock
  7. Guiding the Nextruder cable
  8. Attaching the Nextruder docks
  9. Dock inspection
  10. Dock inspection: video
  11. Version C: Nozzle seal: parts preparation
  12. Version C: Installing the Nextruder nozzle seal
  13. Connecting the Nextruder cables
  14. Wi-fi antenna holder versions
  15. Installing the rear Wi-Fi antenna holder
  16. Connecting the side Wi-Fi antenna
  17. Connecting the Nextruder cables
  18. XL buddy box covering
  19. Guiding the docks PTFE tubes
  20. Guiding the docks PTFE tubes
  21. Installing the Wi-Fi antenna: parts preparation
  22. Installing the Wi-Fi antenna
  23. Spool holder: parts preparation
  24. Assembling the spool holder
  25. Preparing the spool holder
  26. Spool holder: left side
  27. Spool holder: right side assembly
  28. Nextruder assembly: parts preparation
  29. Docking the Nextruder
  30. Nextruder cable bundle assembly
  31. Nextruder cable bundle assembly
  32. Nozzle seal height calibration
  33. Nozzle seal height calibration
  34. Haribo time!
  35. Remaining fasteners
  36. Almost done!
• 6. First run
• Manual changelog XL (Dual-Head to Five-Head upgrade)