EN
  • Čeština
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français
Login

How to assemble the PRUSA PRO face shield

How to assemble the PRUSA PRO face shield

How to assemble the PRUSA PRO face shield
Relevant for:
Last updated 4 years ago
How to assemble the PRUSA PRO face shield
 Difficulty
Very easy
 Steps
6
 Available languages
CSPLDEESITFR
Introduction
Introduction
This guide will take you through the assembly for the PRUSA PRO face shield designed by Prusa Research, which serves as personal protection.
A shorter PDF version of the assembly is available here.
The PRUSA PRO face shield is certified according to the: ČSN EN 166:2002/OPR.1:2010 (EN 166:2001) 1 S 3.
Recommended for a single-use. However, several disinfection methods were tested and approved in certified laboratories. More in the disinfection article.
The printable files including the description of the changes are available at prusaprinters.org
Preparing the face shield parts
Preparing the face shield parts
Preparing the face shield parts
Preparing the face shield parts
WARNING: Wash your hands and your surroundings first, before you start to assemble the face shield. Use the following steps or jump to the last step for a video guide.
Please prepare the following:
Upper part - headband (1x)
Lower part - chin (1x)
Buttonhole elastic band (1x)
Shield from plexiglass (1x)
It is recommended to use gloves during the assembly.
The plexiglass is covered with a protective film from both sides, peel it off carefully. You can use a knife or your fingernail to lift the film up.
Assembling the headband (upper part) on the shield
Assembling the headband (upper part) on the shield
Assembling the headband (upper part) on the shield
Place the plexiglass in front of you, turn the wider side with six holes up. Place the headband near the top edge, see the six pins (protrusions). We will use them to assemble the plexiglass, starting in the middle.
For easier assembly, it is recommended to push your hand through the headband.
Mount the plexiglass on the headband using the third hole from the right. Hold it with your thumb.
Carefully straighten the right side of the headband along the plexiglass and insert the pin. As soon as the pin is through, you can release the thumb.
Straighten the right edge again and insert the marked pin.
Continue on the other side of the headband, apply the same approach. Straighten the headband, avoid bending the plexiglass.
Assembling the elastic band and final check
Assembling the elastic band and final check
Assembling the elastic band and final check
Assembling the elastic band and final check
Take either end of the elastic band and hook it around the protrusion on the end of the headband.
Place the other end of the elastic band on the opposite side of the headband. Adjust the length if needed.
The face shield is ready!!! Disinfect the shield before the use.
To disinfect the shield you can use Prusa Face Shield disinfection
In case you have an idea for any improvement, please contact us using [email protected]. Thank you ;)
Was this guide helpful?

Comments

Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us