English
Login
3D printers
Materials
Parts & Accessories
Software
3D Models
Applications
Community
Help
Academy
Blog
Company
Support
Original Prusa i3 MK3S+
Original Prusa i3 MK3S+ kit assembly (v3.26)
7. Heatbed & PSU assembly | Tools necessary for this chapter
1. Tools necessary for this chapter
Step 1 of 26 (Chapter 8 of 11)
Fullscreen mode
Contents
Comments
⬢
Needle-nose pliers for the heatbed assembly
⬢
2mm Allen key for heatbed alignment
⬢
2.5mm Allen key for M3 screws
Loading...
Next
Contents
Original Prusa i3 MK3S+ kit assembly (v3.26)
1. Introduction
2A. Y-axis assembly
2B. Y-axis assembly
3. X-axis assembly
4. Z-axis assembly
5. E-axis assembly
6. LCD assembly
7. Heatbed & PSU assembly
Tools necessary for this chapter
Heatbed cable assembly (part 1)
Heatbed cable assembly (part 2)
Heatbed cable assembly (part 3)
Preparing the heatbed
Preparing the heatbed-cable-cover
Mounting the heatbed-cable-cover
Mounting the heatbed-cable-cover
Proper cable management
Wrapping the heatbed cables
Securing the sleeve in place
Finalizing the wrap
Preparing the heatbed screws and spacers
Mounting the heatbed (part 1)
Mounting the heatbed (part 2)
Mounting the heatbed (part 3)
Mounting the heatbed (part 4)
Preparing the PSU parts
Assembling the PSU
Assembling the PSU
Connecting the power cables (CRITICAL)
Connecting the power cables
Connecting the power cables
Connecting the power panic
Haribo time!
Heatbed and PSU are done!
8. Electronics assembly
9. Preflight check
Manual changelog MK3S+ kit
Comments
Log in
to post a comment
Malaphor
•
about 3 years ago
Remember to remove any gummy bears if you had been using your hotbed as a staging area as shown in the picture.
Reply
Maxi_90
•
almost 4 years ago
I put the o-ring back on the needle-nose pliers for every step one to follow the instructions EXTREMELY carefully ;)
Reply
