EN
  • Čeština
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français
Login

3. Buffer upgrade

Menu

3. Buffer upgrade

3. Buffer upgrade
Relevant for:
MMU3
Last updated 7 months ago
3. Buffer upgrade
 Difficulty
Easy
 Steps
7
 Available languages
CSPLDEESITFR

Step 1 Buffer cartridge INFO

Buffer cartridge INFO
Buffer cartridge INFO
Buffer cartridge INFO
⬢In this chapter, we will check the MMU3 Buffer.
⬢There have been several versions of the buffer cartridgees available, which might look slightly different.
⬢The MMU3 for the MK4 printer necessitates the use of the most recent buffer cartridge design, Version B.
Version B has been included in MMU3 packages shipped after April 2024. If you have this version, skip this chapter.
The version B accommodates the slightly longer unload distance of the Nextruder. If you're adapting an older MMU3 unit to the MK4, it's necessary to reprint the plastic parts of the buffer cartridge to ensure proper compatibility.
⬢In case you have the version A of the buffer cartridges, proceed to the next step.

Step 2 Buffer preparation

Buffer preparation
Buffer preparation
Buffer preparation
⬢Remove all the PTFE tubes from the buffer segments.
Push the collet in and hold it. Push the PTFE tube in, then pull it out to remove it easily.
⬢Remove all the segments from the buffer.
We need to disassemble the buffer segments and reassemble them using the updated plastic parts.
Save all the hardware components as we will need to reuse them.

Step 3 Segment disassembly (part 1)

Segment disassembly (part 1)
Segment disassembly (part 1)
Segment disassembly (part 1)
⬢Take first of the segments. Orient it so that the side with the three nuts is facing up. Remove the M3x6 bolt.
⬢Turn the segment around.
⬢Remove the remaining four M3x6 bolts.

Step 4 Segment disassembly (part 2)

Segment disassembly (part 2)
Segment disassembly (part 2)
Segment disassembly (part 2)
Segment disassembly (part 2)
⬢Remove both the collets from the buffer segment.
⬢Lift the top section of the buffer segment to take it apart.
⬢Remove the center shaft from the bearing.

Step 5 Segment disassembly (part 3)

Segment disassembly (part 3)
Segment disassembly (part 3)
Segment disassembly (part 3)
⬢Remove the center wheel.
⬢Remove the three M3n nuts from the bottom part of the segment.
Pro tip: use a long M3 bolt partly screwed into the nut. Wiggle it slightly, while pulling the nut out.

Step 6 Buffer segment parts preparation

Buffer segment parts preparation
Buffer segment parts preparation
Buffer segment parts preparation
⬢For the following steps, please prepare:
⬢Buffer Segment (10x)
Make sure you are using the version B of the buffer segments.
⬢Replacing the segment wheels isn’t necessary. We suggest using the old ones with the bearings already in place.
Was this guide helpful?

Comments

Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us