Calibration Error Messages

All articles

• 

  Check Axis Length X/Y/Z (MK3S)

  This error can appear during the Self-test or the XYZ-calibration when the firmware detects a shorter distance of axis travel than expected. The exact length of each axis is stored ...

• 

  Calibration failed

  The Calibration failed error occurs once there is a problem with the calibration. The printer was unable to properly detect the calibration point/s and can not successfully finish the calibration. ...

• 

  XYZ-calibration error-messages (MK3/MK3S/MK3S+)

  From article XYZ Calibration (MK3/MK3S/MK3S+) Initial XYZ Calibration error messages "XYZ calibration failed. Bed calibration point was not found." = Printer was unable to perfectly pinpoint the initial calibration point. "XYZ calibration failed. Please ...

• 

  Distance between tip of the nozzle and the bed surface has not been set yet

  The "Distance between the tip of the nozzle and the bed surface has not been set yet" error message occurs after you successfully finish all of the calibration parts, except ...

• 

  QR Error codes

  This is an advanced system for displaying error screens, providing more useful information to the user. In case of an issue, the printer will display the name of the error ...

• 

  Printer has not been calibrated yet

  The error message Printer has not been calibrated yet occurs after the assembly of your printer or after the Factory reset of all data. It will remain on the main ...

• 

  XYZ Calibration error-messages (MK2/S)

  From article Calibration XYZ (MK2/S)   Initial XYZ Calibration error messages "XYZ calibration failed. Bed calibration point was not found."= Printer was unable to perfectly locate the initial calibration point.   "XYZ calibration failed. Please ...

• 

  End-stop not hitting

  Your printer suspects that everything is not in perfect order with your end-stops.    Wiring issue Make sure there is not a wiring-issue with the X/Y end-stop on the mini RAMBo board. Go to ...

• 

  Static memory has been overwritten

  The printer shows the error message "Static memory has been overwritten". It is caused by too many commands in the memory at the same time, causing it to overflow. The firmware ...

• 

  SL1 Tilt-mechanism error

  This error was changed in firmware version 1.5.0! This article only applies to SL1 printers with firmware older than 1.5.0. During the Wizard, the SL1 will test the tilting-motion of the ...