Purging volumes (MMU)

This article is also available in following languages: 

During a filament change, a small amount of melted plastic remains in the nozzle. As the new filament is loaded, it’s melted as well and starts pushing the nozzle content out. During this time, you’ll see a gradual change in the color of the extruded filament.

In order to ensure a sharp color transition, PrusaSlicer provides several ways to deposit this filament:

• Smart wipe tower
• Wipe to infill
• Wipe to object

The sheep on the right has the white color contaminated by the blue pigment from the previous filament

Purging volumes 

Two modes are possible to set the purging volumes. Use values from configuration, or use custom project-specific settings. 

Use values from configuration

The volume to purge is set by changing the Purging Volume in Printer Settings -> Single extruder MM setup. This value can be further modified on the filament level using Purge Volume Multiplier in Filament Settings -> Advanced. The values cannot be modified in the purging volumes matrix. 

Use custom project-specific settings

Clicking on the purging volumes settings opens a new window that contains a matrix. Each cell represents the amount of filament required to purge during filament change from filament X (left column) to filament Y (top row).

By selecting use custom project-specific settings, you can set each matrix cell individually. The values from the configuration are not used in this mode. 

Example values

Transition Black to White = Black unload + White load = 80 + 70 = 150 mm³

Transition White to Black = White unload + Black load = 20 + 30 = 50 mm³

When using a soluble filament to print supports, or filaments with additives (highly glossy, glitter, etc.), increased purging volumes are most likely needed, compared to the standard example values.