EN
  • Čeština
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français
  • 日本語
Login

Corrupted 3D models for printing

Last updated 2 years ago
This article is also available in following languages: 
CSPLESDEITFRJA

You’d be surprised how many 3D models you can find on the internet are broken in some way. Modern slicers are pretty good at repairing the models without you even noticing. However, not all of the corrupted 3D models can be repaired automatically. Therefore, we would like to give you some tips on how to repair these. 

Repair using PrusaSlicer

PrusaSlicer will automatically repair models to a certain degree, but it may be necessary to fix the model using a dedicated service. If you are using PrusaSlicer under Windows 10, it will have access to Microsoft's APIs for repairing 3D models through Netfabb. 

You can either right-click on the warning symbol found by the name of the model in question (left picture green arrow) or right-click on the model itself and select "Fix by the Netfabb" (right picture red square).

External tools for repairing 3D models

There are several ways to repair a 3D model. You’ll find that sometimes one solution works and another doesn’t, depending on the specific model. We’ll only focus on solutions that are free and easy to use:

 

You can find the entire article about repairing Corrupted 3D models at our blog.
Was this article helpful?

Comments

Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us